It might seem a bit odd discussion, and you may think why anyone wants to learn to make Toilet Paper? Well, when it comes to a survivalist type situation, you’ll regret that you should have learned it. Once must think of sustaining in every situation and not merely focus on water, food, medical supplies.
There are a hell lot of other necessities of life that can be helpful at times.
Toilet paper is something a necessity of life and eventually there comes a time when we run out of it. A healthy reason to make your own paper is that it is eco-friendly and saves a tree. It can be a great Boy or Girl Scout project as well.
So, let us get hooked up with a guide and see what things we need to make toilet paper at home.
Secret Ingredients (Just kidding)
- 8-10 large sheets of newspaper.
- ½ pound of copy paper or a non-glossy magazine page.
- Bucket! A tube would also work.
- A large pot.
- Leaves and grass. Grab them from your backyard.
- A heating source. We recommend using a stovetop, open fire or a propane burner.
- Spoon. A ladle would be better.
- Baby oil (I’ll tell you later why we need this).
- Two large bath towels.
- Rolling pin.
- Rubber mallet.
- Wooden board.
Firstly, soak the paper in a bucket or the tub of water. This helps in getting rid of the ink on the magazine or paper.
Now remove the paper once you notice that 75% of the ink has gone. Next, you have to place the paper in a large pot along with handfuls of leaves and grass. This ensures that that paper fibers remain together and don’t tear apart easily. It also gives strength to the soaked paper.
Fill this pot with water again so that the paper is covered completely.
Place the pot on a heating element and allow it to simmer for about one hour. Make sure that the flame isn’t too much else the water will dry out quickly and might spoil the whole recipe. Gradually boiling helps in absorbing the materials properly in the paper. You may like 15 DIY Toilet Paper Holder Ideas.
Now, raise the temperature so that the water comes to a boil. Allow it to boil for another 30 minutes. You can add more water if necessary.
You may see foam rising above the paper. Remove it time to time using the spoon or ladle. You will notice the paper turning into a pulp during the whole process.
Remove the paper from the heating element and pour out as much water as you can without touching the pulp. Allow the water and pulp to cool down before you remove the remaining water.
Make sure that the pulp doesn’t dry out. Now place the pulp in the pot once you have removed the water. Add approximately four tablespoons of baby oil to this pulp and mix it carefully with a spoon. This is to prevent the pulp from hardening.
Now take a towel, spread it on a flat surface, scoop out the pulp and place it on the towel. Gradually press the pulp with a rolling pin for flattening it and then spread the pulp in a thin layer. Also, use a rubber mallet and gently hammer any lumps you see. Don’t hammer to hard; else the pulp may break.
Once the pulp is flattened, place another towel on top of it and place a board on the top of the second towel. Use a heavy object and place it on the board to add weight to it. This will further squeeze the pulp and remove any excess water. Let the weight sit there for 30 minutes. Learn about choosing toilet for home on Shoptoilet.
Finally, remove the weight, board, and towel. Flip the first towel upside down and remove it gently. Place the dried flattened pulp out in the sun to further dry it.
Once dried, cut the paper into strips and your toilet paper is ready.